Hammer Drive Pins - No Powder Loads Required

Hammer Drive pins are designed for permanently fastening a fixture to concrete and some types of masonry. This fastener is designed for use in a standard hand tool and should not be used in a powder actuated tool. The pins are formed with a 1/4” diameter head on one end and a 0.140” diameter shank in various lengths. A 3/8” diameter steel washer is mounted over the point to retain the drive pin in the fastener guide of the tool providing guidance during the driving operation.

This fastener is recommended for light duty static load applications where holding power is not a critical factor. It should not be used overhead.